Troubleshooting Express Setup
If Express Setup does not run, or if the Express Setup page does not appear in your browser:
•Did you verify that POST successfully ran before starting Express Setup?
•Did you press the Mode button while the switch module was still running POST?
If not, make sure that only the SYST and STAT LEDs are green before pressing the Mode button to enter the Express Setup mode.
If yes, wait until POST completes. Power cycle the switch module. Wait until POST completes. Confirm that the SYST and STAT LEDs are green. Press the Mode button to enter Express Setup mode.
•Did the switch module not power up?
The switch module is controlled by the Onboard Administrator. If the switch module does not power up, see the blade server documentation for more information.
•Did you try to continue without confirming that the switch module was in Express Setup mode?
•Does your PC have a static IP address?
Verify that all LEDs next to the Mode button are green. If necessary, press the Mode button to enter Express Setup mode.
If yes, before connecting to the switch module, change your PC settings to temporarily use DHCP.
•Did you connect a crossover cable instead of a
•Did you connect the Ethernet cable to the console port instead of to an Ethernet port on the switch module?
If yes, connect a
If yes, disconnect the cable from the console port. Then connect the cable to an Ethernet port on the switch module and the PC. Wait 30 seconds before you enter 10.0.0.1 in the browser.
22
