Chapter 1 Module Overview and Specifications
| Ethernet and Fast Ethernet Switching Modules | |
| | |
Specification | Description | |
| | |
Connector type | RJ-45 (See Figure 2-1 on page 2-2.) | |
| | |
Cable type | UTP | |
| | |
Power over Ethernet | Up to 15.4 W per powered device on all 24 ports | |
| (to a 312 W total on the Catalyst 4006) | |
| | |
Power regulation | Internal on the switching module | |
| | |
Figure 1-20 WS-X4224-RJ45V 24-Port IEEE 802.3af-Compliant PoE 10/100BASE-TX Switching Module
113136
To provide PoE with the 24-port PoE 10/100BASE-TX switching module in a Catalyst 4006 switch, you must have a power entry module (PEM) and a power shelf installed. The Catalyst 4006 switch can provide 312 W per PoE module to powered devices. If the powered devices are using the maximum 15.4 W per port, there is only enough power for 18 powered devices. If the powered devices are using less than 15.4 W per port, more powered devices can be powered, up to the 312 W maximum. For more information about installing the PEM or the external power shelf, refer to the Catalyst 4000 Series Installation Guide, Catalyst 4500 Series Installation Guide, Installation and Configuration Note for the Catalyst 4500 Series AC Power Shelf, or the Catalyst 4500 Series Power Entry Module and External Power Shelf Installation Note.
To provide PoE with the 24-port PoE 10/100BASE-TX switching module in a Catalyst 4500 series switch, you must have a PoE-enabled power supply. All power supplies support PoE except the 1000 W and 1400 W AC power supplies.
Note Auto MDIX is not supported on PoE enabled switching modules.
| | Catalyst 4500 Series Module Installation Guide | | |
| | |
| 78-13267-06 | | | 1-21 |
| | |
