Cisco Systems 4000 specifications WS-X4424-GB-RJ45, 1-35, Specification, Description

Chapter 1 Module Overview and Specifications

Gigabit Ethernet Switching Modules

The ports on this switching module can be configured with any combination of shortwave (SX), longwave/long-haul (LX/LH), and long-range (ZX) GBICs. For a description of GBICs, see the “Installing, Removing, and Maintaining GBICs” section on page 2-8.

WS-X4424-GB-RJ45

The WS-X4424-GB-RJ45 24-port 10/100/1000BASE-T Gigabit Ethernet switching module (see Figure 1-32) has the following specifications:

Specification	Description
Module type	10/100/1000 Fast or Gigabit Ethernet switching
	module
Port duplex mode	Half or full duplex mode at 10 and 100 Mbps; full
	duplex mode only at 1000 Mbps
Port speed	10, 100, or 1000 Mbps
Number of ports	24
Connector type	RJ-45 (See Figure 2-1 on page 2-2.)
Cable type	UTP

Note You must use Category 5 cables when connecting to the 1000BASE-T ports on this switching module.

Figure 1-32 WS-X4424-GB-RJ45 24-Port 10/100/1000BASE-T Gigabit Ethernet Switching Module

WS-X4424-GB-RJ45
									24 PORT								MULIT-SPEED
									10/1000/BASE-T
																GIGABIT
																	ETHERNET SWITCHING
STATUS	11	2	3	4	5	6
							7	8
									9	10	11	12	13	14
															15	16	17	18	19	20
																					21	22	23	24

49435

Ports on this switching module may be oversubscribed, depending on utilization. For further information on these ports, see the “Configuring Gigabit Ethernet Ports” section on page 3-9.

	Catalyst 4500 Series Module Installation Guide
78-13267-06		1-35