Cisco Systems 4000 specifications Color/State, Description, 1 Supervisor Engine LEDs

Chapter 1 Module Overview and Specifications

Supervisor Engines

•The Reset button (recessed), which allows you to reset the system

•The CompactFlash port and eject button (WS-X4013+, WS-X4013+ TS, WS-X4013+10GE, WS-4014, WS-X4515, WS-X4516, and WS-X4516-10GE supervisor engines only) (refer to Using the Compact Flash on the Catalyst 4000 Family Supervisor Engine III and IV.)

Table 1-1describes the supervisor engine LEDs.

Table 1-1 Supervisor Engine LEDs

LED	Color/State	Description
STATUS		Indicates the results of a series of self-tests.
	Green	All diagnostic tests passed.
	Red	A test failed.
	Orange	System boot or diagnostic test is in
		progress.
	Off	Module is disabled.
UTILIZATION	Green 1–100%	If the switch is operational, this display
		indicates the current traffic load over the
		backplane (as an approximate percentage).
LINK		Indicates the status of the 10/100BASE-T
		Ethernet management port or uplink ports.
	Green	The link is operational.
	Orange	The link is disabled by user.
	Flashing orange	The power-on self-test indicates a faulty
		port.
	Off	No signal is detected or there is a link
		configuration failure.
ACTIVE		Indicates whether the uplink port is active
		or not.
	Green	The port is active.
	Off	The port is not active.

	Catalyst 4500 Series Module Installation Guide
78-13267-06		1-9