Cisco Systems 78-11424-03 manual Showing RADIUS Server Configuration Information, 2-32

Chapter 2 Configuring User Profiles and CSS Parameters

Configuring the CSS as a Client of a RADIUS Server

To configure the number of RADIUS server retransmits to 5, enter:

(config)# radius-server retransmit 5

To set the RADIUS server retransmit request back to the default of 3 retries, enter:

(config)# no radius-server retransmit

Configuring the RADIUS Server Dead-Time

Use the radius-serverdead-timecommand to set the time interval in which the CSS verifies whether a non-functional server is operational. During the set time interval, the CSS sends probe access-request packets to verify that the RADIUS server (primary or secondary) is available and can receive authentication requests. The dead-time interval starts when the server does not respond to the number of authentication request transmissions configured through the radius-server retransmit command. When the server responds to a probe access-request packet, the CSS transmits the authentication request to the server. Valid entries are 1 to 255 seconds. The default is 5 seconds.

To configure the RADIUS server dead-time to 15 seconds, with probe access-requests enabled, enter:

(config)# radius-server dead-time 15

To set the RADIUS server dead-time request back to the default of 5 seconds, enter:

(config)# no radius-server dead-time

Showing RADIUS Server Configuration Information

Use the show radius command to display information and statistics about the RADIUS server configuration. The syntax and options are:

•show radius config [primarysecondaryall] - Display RADIUS configuration information for a specific server or all servers, identified by type.

•show radius stat [primarysecondaryall] - Display RADIUS authentication statistics for a specific server or all servers, identified by type.

	Cisco Content Services Switch Basic Configuration Guide
2-32	78-11424-03