Cisco Systems 78-11424-03 manual Testing the Output of the XML Code, 2-46

Chapter 2 Configuring User Profiles and CSS Parameters

Configuring Content API

Note Ensure that the CLI commands in the XML document do not have an impact on the interface configuration through which the XML file transfer process is to occur (for example, including the command no ip addr 10.1.2.3, which identifies the IP address of the CSS receiving the XML file). If this occurs, you will disconnect the workstation performing the XML file transfer.

Software is available to simplify the process of publishing XML files to the CSS HTTP server. These software packages offer a simple method to publish files to a Web server. This software uses the HTTP protocol to publish files and require no special software on the Web server side of the connection.

Note An error code in the publishing process usually means that no restrict xml (for CSS software version 4.x) or the webmgmt-state enable (for CSS software version 3.x) commands have not been issued on the CSS prior to publishing the XML file. See the “Controlling Access to the CSS HTTP Server”section for details.

Testing the Output of the XML Code

Test the output of the XML code by reviewing the running configuration of the CSS. After the XML has been successfully published to the CSS, Telnet to the switch and issue the show running-configcommand to verify that the XML changes have properly occurred. If the XML changes are incorrect or missing, republish the XML code to the CSS as described in the “Publishing the XML Code to the CSS” section.

	Cisco Content Services Switch Basic Configuration Guide
2-46	78-11424-03