Cisco Systems AS5400 manual Reconnect all interface cables

Chapter 2 Dial Feature Card and Carrier Card Guidelines

Removing and Installing Populated Carrier Cards

Step 3 Tighten the two captive screws to secure the carrier card to the chassis. (See Figure 2-9and Figure 2-10.)

Figure 2-9 Tighten the Captive Screws on the Cisco AS5350

36005

Captive screw

Captive screw

Figure 2-10 Tighten the Captive Screws on the Cisco AS5400

Captive

screwCaptive screw

37162

Step 4 If the carrier card has a blank DFC slot, install a blank cover over the open DFC slot to ensure proper airflow inside the chassis. (See Figure 2-11.)

Figure 2-11 Blank DFC Cover

36033

Step 5 For AC powered units, reconnect the AC power cord. For DC powered units, remove the tape from the circuit breaker switch handle, and reinstate power by moving the handle of the circuit breaker to the ON position. For more information on the AC and DC power supplies, refer to the chassis installation guide that came with your universal gateway.

Step 6 Reconnect all interface cables.

Cisco AS5350 and Cisco AS5400 Universal Gateway Card Installation Guide

2-6 78-13311-01