Useful Information
For assistance, please visit http://www.panasonic.com/phonehelp 103
Error messages
If the unit detects a problem, one of the following messages is shown on the display.
Display message Cause & solution
Busy LThe called handset or base unit is in use.
LOther users are using the line(s). Wait until the line
button light or the line status icon goes out.
LPrivacy mode is on for the call you tried to join (page
52).
LThe handset or base unit you tried to copy phonebook
items to is in use.
LThe handset you are calling is too far from the base unit.
LAnother handset user is monitoring a room using the
cordless camera.
Camera detect LThe cordless camera paged the handset, but nobody
answered the page. After you monitor the cordless
camera, it disappears from the display.
Denied
Turn access on at
device.
LThe monitor feature is turned off on the destination
handset or base unit and the room cannot be monitored
(page 53).
Error!! LThe handset’s registration or deregistration has failed.
Move the handset and the base unit away from the
electrical appliances and try again.
LAnother handset or base unit user tried to send
phonebook items to you but there was an error. Have
the other user re-send the items to you (page 37, 39).
Error!!
8 handsets have
already been
registered.
L8 handsets have already been registered to the base
unit. The deregistered handset number is still retained
in the base unit. To register an additional handset,
erase the unnecessary handset number using the base
unit (page 78).
Failed LVideo phone feature is not permitted on the other
party’s unit.
LThe video connection failed and you will be returned to
voice call shortly. Wait until it returns to voice call.
LIf the “PC camera access” setting for the base unit is
set to “On”, you cannot use the video phone feature
during an intercom call.
---Incomplete--- LThe destination unit’s phonebook memory is full. Erase
unnecessary items from the destination unit’s
phonebook (page 37, 39).
LThe destination unit is out of area.
LThe destination unit’s user may have pressed {C} or
{s} on the handset or {SP-PHONE} on the base unit.