Cisco Systems AS5400 manual Online Insertion and Removal OIR of the Universal Port DFC, Overview

Chapter 5 Universal Port Dial Feature Card

Online Insertion and Removal (OIR) of the Universal Port DFC

Online Insertion and Removal (OIR) of the Universal Port DFC

Overview

To remove a DFC without dropping any calls or connections, you will need to take the DFC out of service by using the busyout command to disable the DFC. The busyout command is executed on a per DFC basis and will gracefully disable the card by waiting for the active services to terminate.

If you have active calls on the DFC after executing the busyout command, wait for the calls to drop. Use the show busyout command to view the status of the termination process.

Caution To avoid erroneous failure messages, remove or insert only one DFC at a time.

When you replace a DFC with a new DFC of the same type in the same slot, the system software will recognize the new trunk interfaces and bring them up automatically.

If you replace the existing DFC with a new DFC of a different type, you will have to reconfigure the system. For configuration details, refer to the Cisco AS5350 and Cisco AS5400 Universal Gateway Software Configuration Guide. For information on voice and fax commands, refer to the Monitoring Voice and Fax Services on the Cisco AS5350 and Cisco AS5400 Universal Gateways online document.

Removing the Universal Port DFC

To remove the universal port DFC, follow these steps:

Note Following these steps are examples of the output of each command.

Step 1 Determine which slot the DFC is in (see Figure 5-2and Figure 5-3) by entering the show chassis command in privileged EXEC mode:

Router# show chassis slot

Figure 5-2 Slot Numbering on the Cisco AS5350 Chassis

	Slot 0
Slot 2		Slot 1	Slot 3

36006

Cisco AS5350 and Cisco AS5400 Universal Gateway Card Installation Guide

5-2 78-13311-01