Cisco Systems AS5400 manual IN-4

Index

removing a carrier card 2-3

removing the carrier card from the Cisco AS5350 (figure) 2-4

removing the carrier card from the Cisco AS5400

(figure) 2-4
removing the T1 or E1 DFC	3-3
removing the universal port DFC 5-2
required tools and equipment	1-3

RJ-45 to Bare Wire Interface Cable (figure) A-2

RJ-45 to BNC Interface Cable for 75-Ohm, Unbalanced Connections (figure) A-2

RJ-45 to RJ-45 Interface Cable (figure) A-2

RJ-45 to Twinax Interface Cable for 120-Ohm, Balanced Connections (figure) A-2

routing cables with molded RJ-45 ends of cables flush with bracket edges (figure) A-7

routing cables with molded RJ-45 ends of cables next to each other (figure) A-6

RX MON Bantam Jack 6-9

S

safety, ground connections 1-2safety with electricity 1-2

securing the cable bracket to the rack (figure) A-8service and support 2-7,3-14,4-7,5-9,6-10

Slot Numbering on the Cisco AS5350 Chassis

(figure) 3-3,4-2,5-2,6-6

Slot Numbering on the Cisco AS5400 Chassis (figure) 3-4,4-3,5-3,6-6

SPE Firmware 5-9

support, getting technical 2-7,3-14,4-7,5-9,6-10Symbols

Caution viii

Note viii

Timesaver viii

Tips ix

Warning ix

T

T1 and E1 Cable and Port Pinouts					A-1
T1 and E1 Cable Assemblies (table)					A-2
T1 network specifications (table)				3-2
T1 or E1 DFC, overview		3-1
T1 or E1 DFCs (table)		6-3
T1 or E1 Port Pinouts (table)			A-1
T3 cable pinouts	A-10
T3 DFC, installation and removal					4-2
T3 DFC, overview	4-1
T3 DFC LEDs (figure)		6-2
T3 Dial Feature Card (figure)			4-1
Tables
8 PRI T1/E1 DFC Interface Cable					A-3
Bantam Jack Port Pinouts			A-10
CT3 Cable Pinouts A-10
Document Organization vii
E1 Network Specifications			3-2
LEDs 6-3
T1 and E1 Cable Assemblies				A-2
T1 Network Specifications			3-2
T1 or E1 DFC LEDs		6-3
T1 or E1 Port Pinouts		A-1
T3 DFC LEDs	6-4
Universal Port LEDs		6-5
technical assistance, getting			xii
technical support	2-7,3-14,4-7,5-9,6-10
telecommunications lines warning					3-9
testing, using the Bantam Jack ports					6-9

Tighten the Captive Screws on the Cisco AS5350

(figure) 2-6,3-10,4-6,5-8

Tighten the Captive Screws on the Cisco AS5400

(figure)	2-6,3-10,4-7,5-8
timesaver symbol, meaning of		viii
tips symbol, meaning of ix
tools required	1-3
troubleshooting	6-1
troubleshooting, environment		6-6

Cisco AS5350 and Cisco AS5400 Universal Gateway Card Installation Guide

IN-4 78-13311-01