Cisco Systems Cisco 10000 ESR manual Adding or Replacing an AC PEM, Removing the Front Cover

Adding or Replacing an AC PEM

Adding or Replacing an AC PEM

This section describes how to add or replace an AC PEM in the Cisco 10000 chassis. It contains the following procedures:

•Removing the Front Cover, page 5

•Installing a Second AC PEM, page 7

•Replacing an AC PEM, page 12

•Troubleshooting the Installation, page 19

Removing the Front Cover

Use the following procedure to remove the front cover from the system. If your system does not use a front cover, go to the “Installing a Second AC PEM” section on page 7 or to the “Replacing an AC PEM” section on page 12.

Step 1 Unlock each bezel plug by inserting the tip of a flat-blade screwdriver between the top and bottom sections of the plug, and then rotating the screwdriver to unlock the top portion of the plug (Figure 2).

Repeat this procedure for all four bezel plugs and then remove the plugs.

Figure 2 Unlocking the Bezel Plugs

FANS OK

FAN FAILURE

MULTI-FAN FAILURE

POWER

FAULT

MISWIRE

POWER	POWER
FAULT	FAULT
MISWIRE	MISWIRE

Cisco 10000

FANS OK

FAN FAILURE

MULTI-FAN FAILURE

POWER

FAULT

MISWIRE

30038	POWER POWER
	FAULT FAULT
	MISWIRE MISWIRE

Cisco 10000

30039

Cisco 10000 ESR AC Power Entry Module Installation

78-10832-01 5