Cisco Systems Cisco 7505, Cisco 7010 installation instructions Nvram

Replacing the Chassis

The command show interfaces serial slot/port displays statistics for the specific serial interface you specify by its slot/port address. If you use this command without the type and slot/port arguments, the system will display statistics for all interfaces in the system.

Router> show int hssi 1/0

Hssi 1/0 is up, line protocol is up Hardware is cxBus HIP

Internet address is 1.1.1.9, subnet mask is 255.255.255.0 (display text omitted)

The command show configuration displays the contents of the system configuration file stored in

NVRAM.

Router# show config

Using 1652 out of 130048 bytes version 10.3(3)

!

hostname Router

!

enable-password guessagain

!

microcode TRIP flash trip1-0 microcode reload

!

interface hssi1/0 ip address 1.1.1.67 ip route-cache cbus no keepalive

!

interface serial2/1 ip address 1.1.1.12 (display text omitted)

The command show protocols displays the global (system-wide) and interface-specific status of any configured Level 3 protocol.

Router> show protocols

Global values:

Internet Protocol routing is enabled Hssi1/0 is up, line protocol is up (display text omitted)

Cisco 7010 and Cisco 7505 Chassis Replacement Instructions 21