Chapter 2 Installing the Cisco IP Phone 7910 Series
Auto-Registering Your Phone Using TAPS
2-6
Getting Started with the Cisco IP Phone 7910 Series
78-11443-02
Auto-Registering Your Phone Using TAPS
Your administrator may ask you to auto-register your Cisco IP Phone using T APS,
the Tool for Auto-Registered Phones Support. TAPS might be used either for a
new phone or to replace an existing phone.
Note Only follow this procedure if your phone administrator asks you to.
Procedure
Step 1 If the phone is not already installed, see the “Installing the Phone and Connecting
to the Network” section on page 2-3 for instructions on installing the phone
available.
After you plug the phone into a port, the phone automatically registers and
displays a number.
Step 2 Dial the TAPS extension provided by your system administrator.
Step 3 Follow the voice prompts to enter your personal extension number (provided by
your system administrator), followed by #. Listen to the voice prompts to
determine if you need to enter the entire number, including area code.
Step 4 Hang up the phone.
The phone resets and displays your extension number.