Cisco Systems DFC3A Front Stiffener Bracket, Bracket. May Or may not be present Stiffener bracket

Removing the DFC3 Daughter Card

	To remove a DFC3 daughter card from a WS-X6748-GE-TX Ethernet module equipped with a stiffener
	bracket, follow these steps:
Step 1	Attach an ESD grounding strap to your wrist and to ground. (If you are unsure about the correct way to
	attach an ESD grounding strap, refer to the “Attaching Your ESD Grounding Strap” section on page 40
	for instructions.)
Step 2	Remove the WS-X6748-GE-TX Ethernet module from the Catalyst 6500 series switch. (If you are
	unsure about the correct procedure for removing a module from the switch chassis, refer to the
	“Removing and Installing Modules in the Chassis” section on page 32 for removal instructions.)
Step 3	Place the module on an antistatic mat or foam with the front of the module facing toward you.
Step 4	If your DFC daughter card has a small metal installation bracket as shown in Figure 7, use a No.1
	Phillips-head screwdriver to remove the two cap nuts and the one screw securing the bracket. Set them
	aside with the bracket. If there is no installation bracket, remove the two cap nuts and the one screw.
Step 5	Use a Phillips-head screwdriver to remove the remaining securing screws. (See Figure 7.)
	Figure 7	Removing the Securing Screws and Cap Nuts (WS-X6748-GE-TX Equipped with a
		Front Stiffener Bracket)

Installation

bracket. May

or may not be present

Stiffener bracket

WS-X5530-X6748-GE-TX 48 PORT ETHERNET

130149

Stiffener bracket tabs, DFC daughter card mounted underneath tabs.

Catalyst 6500 Series DFC3A, DFC3B, and DFC3BXL Installation Note

78-15893-06 17