Cisco Systems DFC3BXL, DFC3A manual Bracket, Lift here Lift here

Removing the DFC3 Daughter Card

Note The two screws securing the DFC3 daughter card that pass through the front stiffener bracket tabs are longer than the remaining DFC installation screws.

Step 6 With your left hand, lift slightly at the location shown in Figure 8, and gently rock the DFC3 daughter card up and down to unseat the daughter card from the module connectors.

Figure 8	Unseating the DFC Connectors (WS-X6748-GE-TX Equipped with a Front Stiffener
	Bracket)

Lift here

Lift here

WS-X5530-X6748-GE-TX 48 PORT ETHERNET

130150

Step 7 Holding the DFC3 daughter card with both hands, carefully lift the back end of the DFC3 daughter card up slightly to clear the module connectors, and then carefully slide the DFC3 daughter card out from under the two front stiffener bracket tabs. Lift the DFC3 daughter card straight up from the module (see Figure 9) and immediately place the removed DFC3 daughter card on an antistatic mat, antistatic foam pad, or in an antistatic bag.

Catalyst 6500 Series DFC3A, DFC3B, and DFC3BXL Installation Note

18 78-15893-06