Installing the DFC3 Daughter Card
Caution Use care not to damage the connectors on the module. If you damage a connector, it will be necessary to return the module to Cisco for repair.
Step 6 Position the installation bracket over the two male standoffs at the back of the DFC daughter card. Apply pressure to the top of the bracket, as shown in Figure 18 to fully seat the DFC3 daughter card on the module.
Caution When seating the DFC daughter card, do not apply pressure to any other location on the DFC daughter card, especially the heat sinks.
Figure 18 Seating the DFC3 Daughter Card on the Module
Apply pressure to bracket. to seat DFC connectors.
Do not press on heat sinks.
24PORT GIGABIT ETHERNET | - SFP |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |||||
STATUS |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 | 11 | 12 | 13 | 14 | 15 | 16 | 71 | 18 | 19 | 20 | 21 | 22 | 23 | 24 |
99717
Step 7 Use a
Caution You must install screws in all available standoffs. The screws provide grounding between the DFC3 daughter card and the module. Failure to install all of the screws will invalidate the safety approvals and pose a risk of fire and electrical hazard.
Catalyst 6500 Series DFC3A, DFC3B, and DFC3BXL Installation Note
26 |
| |
|
