Cisco Systems H.323 appendix Type, Description, 3 Static System Data Parameters continued

Chapter 3 Provisioning the Cisco HSI

Cisco HSI Configuration

Table 3-3 Static System Data Parameters (continued)

Parameter	Type	Description
PavoRedirPresInd	[0-3]	The value of the Pavo redirecting number presentation indicator. (If this
		parameter is not provisioned, the default is Q.931 zero—no indication.)
CliInDisplaySupported	STRING	If this parameter is present and set to anything other than “”, the Calling Number
		is also sent in the DISPLAY IE. The NetMeeting endpoint retrieves the calling
		party number from the DISPLAY IE in the H.225 setup message. To enable this
		parameter, set it to “Enabled.”
T38MaxVal	STRING	The T38MaxVal parameter has the following optional attributes that can be
		assigned values in a specific range.
		Note Values for the following attributes must be expressed in hexadecimal
		format.
		• MaxBit—[0x0—0xFFFFFFFF]. Specifies the maximum bit rate in units
		of 100 bits per second at which a transmitter can transmit or a receiver
		can receive T.38 FAX data. The default value is 0x90.
		• FxMaxBuf—[0x0—0xFFFFFFFF]. Specifies the maximum buffer size
		for the "t38FaxMaxBuffer" parameter for the T.38 over UDP option. The
		default value is 0xc8.
		• FxMaxData—[0x0—0xFFFFFFFF]. Specifies the maximum datagram
		size for the "t38FaxMaxDatagram" parameter for the T.38 over UDP
		option. The default value is 0x48.
T38Options	STRING	This T.38 Fax parameter is assigned one of the following optional values:
		• FxFillBit—[0 or 1] The default value is 0.
		• FxTransMMR—[0 or 1] The default value is 0.
		• FxRateTransJBIG—[0 or 1] The default value is 0.
		• FXRate—[Local or Trans] The default value is Trans.
		• FxUdpEC—[Red or FEC] The default value is Red.
AsymmetricHandlingSupported	STRING	Asymmetric Codec Treatment support is enabled if this parameter is present and
		set to anything other than “”. To enable Asymmetric Codec Treatment, set this
		parameter to “Enabled.”
UseConfID	STRING	Use this parameter to specify the precedence of extracting the Global Call ID
		from the Conference ID or the GUID in the H.225 Setup message. The
		provisioning of this property to a value other than “” gives precedence to the
		Conference ID. For example, set it to “Enabled.” To set the precedence to the
		GUID field, the crafts person can either delete the property from the config or
		set it to “”.

	Cisco H.323 Signaling Interface User Guide
3-6	OL-4806-01 Rev. A14