Cisco Systems H.323 appendix Parameter Values, 3-20, Parameter Name, Description

Chapter 3 Provisioning the Cisco HSI

H.323 Stack Configuration

Table 3-14 Common Static System Data Parameters

Parameter Name	Parameter Values	Description
CarrierCodeMapping	• “enabled”—a string that indicates the	Allows the mapping of a special tech prefix (the
	feature is enabled.	format of which is CCxCy) to the
	• Blank (“”)—indicates the feature is	DestinationCircuitID “group” field in the ARQ
		message. This feature works only with IOS
	disabled.
		Gatekeeper build Release 12.2(15)T10 or above.
	• “deleted”—indicates that the feature
	is disabled.
ClipClirSupported	• “enabled”—a string that indicates the	Allows transit of CLI presentation/screening
	feature is enabled.	information.
	• Blank (“”)—indicates the feature is	Note Setting this parameter to “enabled”
	disabled	enables use of Caller ID.
	• “deleted”—indicates that the feature
	is disabled
DtmfSupportedType	• “dtmf”—the recommended value for	Selects the DTMF type during H.245 terminal
	interworking with Cisco gateways	capabilities exchange.
	• “basicString”	Note Set this parameter to “dtmf” and the
		DtmfSupportedDirection parameter to
		“both” to enable DTMF support.
DtmfSupportedDirection	• “tx”—transmit to H323 endpoint	Selects DTMF transit direction.
	• “rx”—receive from H.323 endpoint	Note Set this parameter to “both” and the
	• “both”—transmit and receive DTMF	DtmfSupportedType parameter to “dtmf”
		to enable DTMF support.
	• Blank (“”), “deleted,” or any other
	string, such as “disabled”—indicates
	the feature is disabled
H225PavoSupported	• “enabled”—a string that indicates the	Allows transit of redirecting number parameter
	feature is enabled.	(contained in Cisco CallManager H.225 setup
	• Blank (“”)—indicates the feature is	messages—nonStandardControl field).
	disabled
	• “deleted”—indicates that the feature
	is disabled
RaiSupported	For example:	Allows H.225 RAS RAI messages to be sent to the
	• “enabled”—a string that indicates the	gatekeeper if the E-ISUP link fails or if the HSI is
	feature is enabled.	under heavy load.
	• Blank (“”)—indicates the feature is	Note Set this parameter to “enabled” to enable
		the HSI to support RAI messages.
	disabled
	• “deleted”—indicates that the feature
	is disabled

	Cisco H.323 Signaling Interface User Guide
3-20	OL-4806-01 Rev. A14