Cisco Systems H.323 System Configuration Data, Reverting to the Base Configuration, Example

Chapter 3 Provisioning the Cisco HSI

Cisco HSI Configuration

Step 2 To display the entire configuration, issue the following command:

rtrv-config

To display a subset of the configuration, one can issue a command such as the following:

rtrv-config:sys_config_static

Step 3 To exit the MML command interpreter, issue the following command:

quit

Reverting to the Base Configuration

The following MML command examples show how to revert to the base HSI configuration:

Step 1 To begin an MML session, issue the following command:

mml

Step 2 To revert to the base HSI configuration, issue the following command:

restart-softw:init

Note The restart-softw:initcommand is derived from the initial installation script. (See Step 6 in the “Installing Cisco HSI” section on page 2-5.) To return to the configuration “myconf,” one would issue the command restart-softw:myconf.

System Configuration Data

System configuration data can be static or dynamic. Static data can be activated only at startup. Dynamic data can be activated during system run time.

Static System Data

To modify the static system data parameters in Table 3-3, use the sys_config_static MML name variable for the prov-add, prov-dlt, and prov-edcommands. Stop and restart the application for the changes to take effect.

In the following example, the prov-addcommand adds the static system data parameter

VSCA_PORT_NUMBER1 to a static configuration file. The prov-edcommand modifies the value of the VSCA_PORT_NUMBER1 parameter. The prov-dltcommand deletes the VSCA_PORT_NUMBER1 parameter from the static configuration file.

Example

prov-add:name=sys_config_static,vsca_port_number1=8003 prov-ed:name=sys_config_static,vsca_port_number1=8002 prov-dlt:name=sys_config_static,vsca_port_number1

The parameters in Table 3-3are written to a static configuration file or to a section within a file.

	Cisco H.323 Signaling Interface User Guide
3-4	OL-4806-01 Rev. A14