1-11
Cisco IE 3010 Switch Software Configuration Guide
OL-23145-01
Chapter 1 Overview
Default Settings After Initial Switch Configuration
• Digital optical monitoring (DOM) to check status of X2 small form-factor pluggable (SFP) modules
Default Settings After Initial Switch Configuration
The switch is designed for plug-and-play operation, requiring o nly that you assign basic IP information
to the switch and connect it to the other devices in your network. If you have specific network needs,
you can change the interface-specific and system-wide settings.
Note For information about assigning an IP address by using the browser-based Expre ss Setup program, see
the getting started guide. For information about assigning an IP ad dress by using the CLI-based setup
program, see the hardware installation guide.
If you do not configure the switch at all, the switch operates with these default settings:
• Default switch IP address, subnet mask, and default gateway is 0.0.0.0. For more information, see
Chapter 3, “Assigning the Switch IP Address and Default Gateway,” and Chapter 21, “Configuring
DHCP Features and IP Source Guard Features.”
• Default domain name is not configured. For more information, see Chapter 3, “Assigning the Switch
IP Address and Default Gateway.”
• DHCP client is enabled, the DHCP server is enabled (only if the device acting as a DHCP server is
configured and is enabled), and the DHCP relay agent is enabled (only if the device is acting as a
DHCP relay agent is configured and is enabled). For more information, see Chapter 3, “Assigning
the Switch IP Address and Default Gateway,” and Chapter 21, “Configuring DHCP Features and IP
Source Guard Features.”
• Switch cluster is disabled. For more information about switch clusters, see Chapter 5, “Clustering
Switches,” available on Cisco.com.
• No passwords are defined. For more information, see Chapter 6, “Administering the Switch.”
• System name and prompt is Switch. For more information, see Chapter 6, “Administering the
Switch.”
• NTP is enabled. For more information, see Chapter 6, “Administering the Switch.”
• DNS is enabled. For more information, see Chapter 6, “Administering the Switch.”
• TACACS+ is disabled. For more information, see Chapter 9, “Configuring Switch-Based
Authentication.”
• RADIUS is disabled. For more information, see Chapter 9, “Configuring Switch-Based
Authentication.”
• The standard HTTP server and Secure Socket Layer (SSL) HTTPS server are both enabled. For more
information, see Chapter 9, “Configuring Switch-Based Authentication.”
• IEEE 802.1x is disabled. For more information, see Chapter 10, “Configuring IEEE 802.1x
Port-Based Authentication.”
• Port parameters
–
Operating mode is Layer 2 (switchport). For more information, see Chapter 12, “Configuring
Interface Characteristics.”
–
Interface speed and duplex mode is autonegotiate. For more information, see Chapter 12,
“Configuring Interface Characteristics.”