33-18
Cisco IE 3010 Switch Software Configuration Guide
OL-23145-01
Chapter 33 Configuring QoS
Configuring Auto-QoS
You can combine the commands described in this section to prioritize traffic by placing packets with
particular DSCPs or CoSs into certain queues, by allocating a large queue size or by servicing the queue
more frequently, and by adjusting queue thresholds so that packets with lower priorities are dropped. For
configuration information, see the “Configuring Egress Queue Characteristics” section on page 33-69.
Note The egress queue default settings are suitable for most situations. You should change them only when
you have a thorough understanding of the egress queues and if these settings do not meet your QoS
solution.

Packet Modification

A packet is classified, policed, and queued to provide QoS. Packet modifications can occur during this
process:
• For IP and non-IP packets, classification involves assigning a QoS label to a packet based on the
DSCP or CoS of the received packet. However, the packet is not modified at this stage; only an
indication of the assigned DSCP or CoS value is carried along. The reason for this is that QoS
classification and forwarding lookups occur in parallel, and it is possible that the p acket is forwarded
with its original DSCP to the CPU where it is again processed through software.
• During policing, IP and non-IP packets can have another DSCP assigned to them (if they are out of
profile and the policer specifies a markdown DSCP). Once again, the DSCP in the packet is not
modified, but an indication of the marked-down value is carried along. For IP packets, the packet
modification occurs at a later stage; for non-IP packets the DSCP is converted to CoS and used for
queueing and scheduling decisions.
• Depending on the QoS label assigned to a frame and the mutation chosen, the DSCP and CoS values
of the frame are rewritten. If you do not configure the mutation map and if you configure the port to
trust the DSCP of the incoming frame, the DSCP value in the frame is not changed, but the CoS is
rewritten according to the DSCP-to-CoS map. If you configure the port to trust the CoS of the
incoming frame and it is an IP packet, the CoS value in the frame is not changed, but the DSCP might
be changed according to the CoS-to-DSCP map.
The input mutation causes the DSCP to be rewritten depending on the new value of DSCP chosen.
The set action in a policy map also causes the DSCP to be rewritten.
Configuring Auto-QoS
You can use the auto-QoS feature to simplify the deployment of QoS features. Auto-QoS determines the
network design and enables QoS configurations so that the switch can prioritize different traffic flows.
It uses the ingress and egress queues instead of using the default (disabled) QoS behavior. The switch
offers best-effort service to each packet, regardless of the packet conten ts or size, and sends it from a
single queue.
When you enable auto-QoS, it automatically classifies traffic based on the traffic type and ingress packet
label. The switch uses the classification results to choose the appropriate egress queue.
Auto-QoS supports IPv4 and IPv6 traffic when you configure the dual IPv4 and IPv6 SDM template with
the sdm prefer dual ipv4-and-ipv6 global configuration command.