Verifying the Installation
Route Processor LEDs (Cisco 7000)
Figure 15 shows the LEDs on an RP installed in the chassis. The three LEDs on the RP indicate the system and RP status. When the system is turned on or restarted, the boot error LED goes on for one or two seconds, then goes out. The CPU halt LED, which goes on only if the system detects a processor hardware failure, should never go on. If the boot error LED remains on for more than five seconds, the system is unable to boot and should be restarted. A successful boot is indicated when the boot error LED goes out; however, this does not necessarily mean that the system has reached normal operation. During normal operation, the CPU halt and boot error LEDs should be off, and the normal LED should be on.
Figure 15 RP LEDs
NORMAL
BOOT CPU HALT
ERROR
H1363a
Cisco 7000 and Cisco 7507 Chassis Replacement Instructions 29
