Verifying the Installation
Route Switch Processor LEDs (Cisco 7507)
Figure 16 shows the two LEDs on the RSP2. They indicate the system and RSP2 status. The normal LED goes on to indicate that the system is operational. During normal operation, the CPU halt LED on the RSP2 should be off and stay off unless the system detects a processor hardware failure. A successful boot is indicated when the normal LED comes on and stays on; however, this does not necessarily mean that the system has reached normal operation. The slot 0 and slot 1 LEDs indicate which PCMCIA slot is in use and blink when either slot is being accessed by the system, if a Flash memory card is installed.
Figure 16 RSP2 LEDs
NORMAL
| EJECT |
| ||
SLOTSLOT | 1 |
|
| |
0 |
|
|
| |
MASTER |
|
| ||
SLAVE |
|
|
|
|
| SLAVE/MASTER |
| ||
| CPU | HALT |
| |
|
|
|
| |
| RESET | H3071 | ||
|
|
|
| |
