Cisco Systems PA-5EFL=, 10BASE-FL manual What Is the 5EFL Port Adapter?

What Is the 5EFL Port Adapter?

Table 4 lists multimode optical-fiber parameters.

Table 4	Multimode Optical-Fiber Parameters
Parameter	Multimode
Size	62.5/125 micrometer (nominal diameter) optical fiber 1
Attenuation	3.75 dB/km, at 850 nanometers (nm)
Insertion loss	< 12.5 dB, at 850 nm
Bandwidth	> 160MHzkm, at 850 nm
Propagation delay	5 microseconds/km

1 Specified in IEC Publication 793-2[14].

What Is the 5EFL Port Adapter?

The 5EFL port adapter provides up to five IEEE 802.3 Ethernet 10BASE-FL interfaces. (See Figure 1.) Each Ethernet 10BASE-FL interface allows a maximum bandwidth of 10 Mbps, for a maximum aggregate bandwidth of 50 Mbps, half-duplex. Each 10BASE-FL interface uses two multimode (ST) receptacles for receive (RX) and transmit (TX). All five ports run at wire speed.

Figure 1	5EFL Port Adapter, Faceplate View
EN								ETHERNET-10BFL
RX	TX	RX	TX	RX	TX	RX	TX	RX	TX
0			1	2			3	4

H6471

Port Adapter Locations on the VIP2 and in the Cisco 7200 Series Routers

This section provides information about where you can install the 5EFL port adapter on the VIP2 and in the Cisco 7200 series routers.

Note Port adapters have handles that allow for easy installation and removal; however, they are occasionally not shown in this publication to highlight port adapter faceplate detail.

Figure 2 shows a VIP2-15 or VIP2-40 with two installed port adapters. Figure 3 shows a VIP2-50 with two installed port adapters. With the VIP2 oriented as shown, the left port adapter is in port adapter slot 0, and the right port adapter is in port adapter slot 1.

8PA-5EFL Ethernet 10BASE-FL Port Adapter Installation and Configuration