Tools and Parts Required

Tools and Parts Required

You need the following tools and parts to install a port adapter. If you need additional equipment, contact a service representative for ordering information.

PA-5EFL(=) port adapter and one of the following:

VIP2-15(=), VIP2-20=, VIP2-40(=) or VIP2-50(=)

Cisco 7200 series router with at least one available port adapter slot

Cables appropriate for the port adapter interfaces (ST-type optical-fiber cables are not available from Cisco Systems; they are available from outside commercial cable vendors.)

Number 1 Phillips and a 3/16-inch, flat-blade screwdriver.

Your own ESD-prevention equipment or the disposable grounding wrist strap included with all upgrade kits, FRUs, and spares.

Software and Hardware Requirements

Table 1

PA-5EFL Port Adapter Software Requirements

 

 

Router Platform

Minimum Cisco IOS Release

 

 

Cisco 7000 series and Cisco 7500 series

 

• With VIP2-15 or VIP2-40

Cisco IOS Release 11.1(472) or a later release of Cisco IOS Release 11.1

 

Cisco IOS Release 11.1(6)CA or a later release of Cisco IOS Release 11.1 CA

 

Cisco IOS Release 11.2(1) or a later release of Cisco IOS Release 11.2

 

Cisco IOS Release 11.2(6)P or a later release of Cisco IOS Release 11.1 P

 

Cisco IOS Release 11.1(14)CA or a later release of Cisco IOS Release 11.1 CA

• With VIP2-50

Cisco IOS Release 11.1(14)CA or a later release of Cisco IOS Release 11.1 CA

 

 

Cisco 7200 series

 

• Cisco 7204VXR and Cisco 7206VXR

Cisco IOS Release 12.0(3)T or a later release of Cisco IOS Release 12.0 T

 

Cisco IOS Release 12.0(2)XE2 or a later release of Cisco IOS Release 12.0 XE

• Cisco 7204 and Cisco 7206

Cisco IOS Release 11.1(9)CA1 or a later release of Cisco IOS Release 11.1 CA

• Cisco 7202

Cisco IOS Release 11.1(19)CC1 or a later release of Cisco IOS Release 11.1 C

 

Cisco IOS Release 11.3(4)AA or a later release of Cisco IOS Release 11.3 AA

 

 

In the Cisco 7000 series or Cisco 7500 series routers, the 5EFL port adapter requires the following VIP2 models:

VIP2-15 (1 MB of SRAM, 8 MB of DRAM)

VIP2-20 (1 MB of DRAM, 16 MB of SRAM)

VIP2-40 (2 MB of SRAM, 32 MB of DRAM)

VIP2-50 (4 to 8 MB of SRAM, 32 to 128 MB of DRAM)

Caution To prevent system problems, the VIP2 requires that the Cisco 7000 series router has the RSP7000 and RSP7000CI installed. The VIP2 will not operate properly with the Route Processor (RP), Switch Processor (SP), or Silicon Switch Processor (SSP) installed in the Cisco 7000 series router.

PA-5EFL Ethernet 10BASE-FL Port Adapter Installation and Configuration 3

Page 3
Image 3
Cisco Systems 10BASE-FL, PA-5EFL= manual Tools and Parts Required, Software and Hardware Requirements