5EFL Port Adapter Multimode Fiber-Optic Cable and Receptacles

5EFL Port Adapter Multimode Fiber-Optic Cable and Receptacles

The interface connectors on the 5EFL port adapter are five pairs of (ST) receptacles, designated as RX and TX. You can use all five connection pairs simultaneously or any combination of each pair individually. Each connection pair supports IEEE 802.3 and Ethernet 10BASE-FL interfaces compliant with appropriate standards. Figure 6 shows the ST fiber-optic cable plug used for RX and TX connections.

Figure 6 Ethernet 10BASE-FL Fiber-Optic Cable Plug (ST Type)

H1348a

Note The 5EFL interfaces on a VIP2 are configured for 10 Mbps, half duplex, for a maximum aggregate bandwidth of 50 Mbps for half-duplex. Cisco Systems does not supply ST-type optical-fiber cables; these cables are available commercially. For ST-type, multimode optical-fiber cable specifications and transmission distance limitations and requirements, refer to the section “IEEE 802.3 10BASE-FL Specifications” on page 7.

VIP2 and the 5EFL Port Adapter

This section describes the 5EFL port adapter and its use with the VIP2.

The following sections provide additional information specific to the 5EFL port adapter and its use on the VIP2 in Cisco 7000 series and Cisco 7500 series routers:

Installing or Replacing a Port Adapter on a VIP2, page 13

Attaching 5EFL Port Adapter Interface Cables, page 17

Configuring the 5EFL Interfaces, page 17

Selecting Chassis Slot, Port Adapter, and Ethernet 10BASE-FL Interface Port Numbers, page 18

Configuring the 5EFL Interfaces, page 17

Checking the Configuration, page 20

The 5EFL port adapter can be installed on the VIP2 in port adapter slot 0 and port adapter slot 1. Figure 7 shows two 5EFL port adapters installed in port adapter slots 0 and 1 on a VIP2-15 or VIP2-40.

PA-5EFL Ethernet 10BASE-FL Port Adapter Installation and Configuration 11

Page 11
Image 11
Cisco Systems PA-5EFL= manual VIP2 and the 5EFL Port Adapter, Ethernet 10BASE-FL Fiber-Optic Cable Plug ST Type