VIP2 and the 5EFL Port Adapter

Figure 9

Location of Port Adapter Screw (Partial Port Adapter View)

H3148

Screw

Step 6 Remove the screw that secures the port adapter (or blank port adapter).

Step 7 With the screw removed, grasp the handle on the front of the port adapter (or blank port adapter) and carefully pull it out of its slot, away from the edge connector at the rear of the slot. (See Figure 10.)

Figure 10 Pulling a Port Adapter Out of a Slot (Partial Port Adapter View)

H3149

Step 8 If you removed a port adapter, place it in an antistatic container for safe storage or shipment back to the factory. If you removed a blank port adapter, no special handling is required; however, store the blank port adapter for potential future use.

14PA-5EFL Ethernet 10BASE-FL Port Adapter Installation and Configuration

Page 14
Image 14
Cisco Systems PA-5EFL=, 10BASE-FL manual Screw