Cisco Systems 10BASE-FL, PA-5EFL= manual Attaching 5EFL Port Adapter Interface Cables

Attaching 5EFL Port Adapter Interface Cables

Attaching 5EFL Port Adapter Interface Cables

On a single 5EFL port adapter, you can use up to five pairs of ST fiber-optic connections. The 5EFL port adapter is an end station device and not a repeater. You must connect the 5EFL port adapter to a 10BASE-FL repeater or hub. ST-type fiber-optic cables are not available from Cisco Systems; they are available from outside commercial cable vendors.

Use the following procedure to connect ST fiber-optic cables to the 5EFL port adapter:

Step 1 Attach the RX multimode fiber-optic cable directly to the RX port on the 5EFL port adapter. (See Figure 13.)

Note Port adapters have a handle attached, but this handle is not shown to allow a full view of detail on each port adapter’s faceplate.

Step 2 Attach the TX multimode fiber-optic cable directly to the TX port on the 5EFL port adapter. (See Figure 13.)

Figure 13 Connecting 5EFL Port Adapter ST Cable Pairs

EN								ETHERNET-10BFL
		RX
RX	TX		TX	RX	TX	RX	TX	RX	TX
	0		1		2		3	4

RXTX

ST-type optical-fiber cables; two for each 5EFL port

H6770

To the appropriate TX and RX ports of the repeater, hub, DTE or other external 10BASE-FL equipment

Step 3 Connect a 5EFL RX port to the appropriate TX port of the repeater, hub, DTE or other external 10BASE-FL equipment.

Step 4 Connect a 5EFL TX port to the appropriate RX port of the repeater, hub, DTE or other external 10BASE-FL equipment.

Step 5 Repeat Steps 1 and 4 for each additional 5EFL interface connection you require.

This completes cable connection to the 5EFL port adapter.

Configuring the 5EFL Interfaces

If you installed a new 5EFL port adapter or if you want to change the configuration of an existing interface, you must enter configuration mode using the configure command. If you replaced a 5EFL port adapter that was previously configured, the system will recognize the new 5EFL interfaces and bring them up in their existing configuration.

PA-5EFL Ethernet 10BASE-FL Port Adapter Installation and Configuration 17