Configuring the 5EFL Interfaces
Note If you remove the
Figure 14
5EFL in port adapter slot 0
(port numbers 3/0/0, 3/0/1, 3/0/2, 3/0/3, 3/0/4 from left to right)
5EFL in port adapter slot 1
(port numbers 3/1/0, 3/1/1, 3/1/2, 3/1/3, 3/1/4 from left to right)
|
|
|
|
|
|
|
|
|
|
|
|
| HALT |
|
|
|
|
| ROUTE SWITCH PROCESSOR |
| ||
|
|
|
|
|
| EJECT | SLOT | 1 |
|
|
| CPU | RESET |
|
|
|
|
| CONSOLE |
|
| |
| NORMAL |
|
|
|
|
| 0 |
|
|
|
|
|
|
|
|
|
| |||||
|
|
|
|
|
| SLOT |
|
|
|
|
|
|
|
|
|
|
|
| ||||
|
|
|
|
|
|
|
|
|
|
|
| EN | RX | TX | RX | TX | RX | TX | RX | TX | TX | |
|
|
|
|
|
|
|
|
|
|
| RX | |||||||||||
EN | RX | TX | RX | TX | RX | TX | RX |
| TX | RX | TX |
|
| 0 |
| 1 |
| 2 |
| 3 | 4 |
|
|
| 0 |
| 1 |
| 2 | 3 |
|
| 4 |
|
|
|
|
|
|
|
|
|
|
| |
H6582
Slot 3 |
|
Slot 2 | Interface |
Slot 1 | processor |
slots | |
Slot 0 |
|
You can identify interface ports by physically checking the slot/port adapter/interface port location on the back of the router or by using show commands to display information about a specific interface or all interfaces in the router.
Configuring Interfaces
The following steps describe a basic configuration. Press the Return key after each step unless otherwise noted. At any time you can exit the privileged level and return to the user level by entering disable at the prompt as follows:
Router# disable
Router>
Use the following procedure to perform a basic configuration:
Step 1 At the
terminal will be the source of the configuration subcommands, as follows:
Router# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#
Step 2 At the prompt, specify the first interface to configure by entering the subcommand interface, followed by the type (ethernet) and slot/port adapter/interface (interface processor slot number). The example that follows is for the first interface of the first port adapter, on a VIP2 in interface processor slot 1:
Router(config)# interface e 1/0/0
