Installing a Cisco
Installing a Cisco uBR10-LCP2-MC28C Cable Interface Line Card
Tools and Parts Required
To remove and replace an individual cable interface line card you need the following tools and parts:
•Replacement cable interface line card (order number
•
•
•Blank line card cover (order number
Note For proper cooling and airflow, you must always install a blank cable interface line card cover in a blank line card slot. The product order number for the blank cable interface line card cover is
Unpacking and Preparing
Tip Make sure that you are using the
Step 1 Open the shipping carton by cutting the packing tape along the flaps on the top of the box. Step 2 Remove the cable interface line card.
Step 3 Place the cable interface line card on an
Removing a Cable Interface Line Card from the Chassis
Use the following procedure to remove the Cisco
To prevent alarms from activating, you must administratively shut down a cable interface line card before hot swapping it. Refer to “Shutting Down and Restarting the Interface” in the Cisco uBR10012 Software Configuration Guide at the following URL:
http://www.cisco.com/univercd/cc/td/doc/product/cable/ubr10k/ubr10012/index.htm
See the release notes at the following URL:
http://www.cisco.com/univercd/cc/td/doc/product/cable/ubr10k/ub10krns/index.htm
Otherwise, inform the network administrator that this portion of the network will be temporarily interrupted. If the maintenance LED is on, you can remove the cable interface line card without affecting system operations.
Cisco
12 |
| |
|
