Cisco Systems WEC600N No Wi-Fi Protected Setup, Wireless Security Disabled, Click Connect Anyway

Chapter 3

Configuration

If the router does not support Wi-Fi Protected Setup, proceed to the section, “No Wi-Fi Protected Setup”. If the router supports Wi-Fi Protected Setup , proceed to the section, “Wi-Fi Protected Setup”.

No Wi-Fi Protected Setup

If the router does not use Wi-Fi Protected Setup, proceed to the appropriate section, “Wireless Security Disabled” or “Wireless Security Enabled”.

Wireless Security Disabled

If you connect to a network whose wireless security is disabled, then you will view this screen:

Click Connect Anyway

1.Click Connect Anyway.

2.Click Finish.

Congratulations

Congratulations! The Adapter is connected to

the network.

Wireless Security Enabled

If you connect to a network whose wireless security is enabled, then you will view one of three screens.

1.Proceed to the appropriate instructions.

WPA2 (Wi-Fi Protected Access 2)

If the network uses WPA2 Personal security, then the WPA2-Personal Key Needed for Connection screen appears.

WPA2-Personal Security

Passphrase  Enter the network’s Passphrase (also called a pre-shared key) of 8-63 characters.

To connect to the network, click Connect. To cancel the connection, click Cancel.

WPA (Wi-Fi Protected Access)

If the network uses WPA Personal security, then the WPA-Personal Key Needed for Connection screen appears.

WPA-Personal Security

Passphrase  Enter the network’s Passphrase (also called a pre-shared key) of 8-63 characters.

To connect to the network, click Connect. To cancel the connection, click Cancel.

WEP (Wired Equivalent Privacy)

If the network uses WEP encryption, then the WEP Key or Passphrase Needed for Connection screen appears.

Dual-Band Wireless-N ExpressCard 9