Chapter 1

Product Overview

Reset  There are two ways to reset the Router’s factory defaults. Either press and hold the Reset Button for approximately five seconds, or restore the defaults from the Administration > Factory Defaults screen in the Router’s browser-based utility (refer to

Administration > Factory Defaults, page 32).

Power Switch  Press I the end to power on the Router. Press the O end to power off the Router.

Power  The Power port is where you connect the power adapter.

Horizontal Placement

The Router has four rubber feet on its bottom panel. Place the Router on a level surface near an electrical outlet.

Wall-Mounting Placement

The Router has two wall-mount slots on its bottom panel. The distance between the slots is 175.56 mm (6.91 inches).

Two screws are needed to mount the Router.

Suggested Mounting Hardware

2.5-3.0 mm

4-5 mm

1-1.5 mm

††Note: Mounting hardware illustrations are not true to scale.

NOTE: Linksys is not responsible for damages incurred by unsecured wall-mounting hardware.

Follow these instructions:

1.Determine where you want to mount the Router. Make sure that the wall you use is smooth, flat, dry, and sturdy. Also make sure the location is within reach of an electrical outlet.

2.Drill two holes into the wall. Make sure the holes are 175.56 mm (6.91 inches) apart.

3.Insert a screw into each hole and leave 3 mm (0.12 inches) of its head exposed.

4.Position the Router so the wall-mount slots line up with the two screws.

5.Place the wall-mount slots over the screws and slide the Router down until the screws fit snugly into the wall-mount slots.

175.56mm

(6.91 in)

Print this page at 100% size.

Cut along the dotted line, and place on the wall to drill precise spacing.

Wall-Mounting Template

Simultaneous Dual-Band Wireless-N Gigabit Router

4

Page 6
Image 6
Cisco Systems WRT610N manual Horizontal Placement, Wall-Mounting Placement