Cisco Systems 6500-E, WS-C6513-E-RF mm Gap between the module EMI gasket and the module above it

Installing and Removing the Module

Figure 6 Clearing the EMI Gasket in a Horizontal Slot Chassis

	WS-X6K-SUP2-2GE
1		CONSOLE
		PORT
	CONSOLE	MODE
	SUPERVISOR2
	WS-X6K-SUP2-2GE
2		CONSOLE
		PORT
	CONSOLE	MODE
	SUPERVISOR2
3
Press down
4
FAN	WS-X6224
STATUS
5
	24 PORT 100FX

6

	Switch	Load
	100%
		PORT 1	PORT 2
PCMCIA	EJECT
	1%
	Switch	Load
	100%
		PORT 1	PORT 2
PCMCIA	EJECT
	1%

Press down

SELECT

NEXT

3

4 4

	WS-C6500-SFM
5	5
	SWITCH
	FABIRD MDL
6	6

S
TU	E
TA	TIV
S	AC

1 mm Gap between the module EMI gasket and the module above it

58570

b.Using the thumb and forefinger of each hand, grasp the two ejector levers and press down to create a small (0.040 inch [1 mm]) gap between the EMI gasket and the module above it. (See Figure 6.)

Caution Pressing down too firmly on the levers will bend and damage them.

c.While pressing down, simultaneously close the left and right ejector levers to fully seat the module in the backplane connector. The ejector levers are fully closed when they are flush with the module faceplate. (See Figure 7.)

Cisco Communication Media Module for Catalyst 6500 Series Switch and Cisco 7600 Series Router Installation and Verification Note

13