Manuals / Cisco Systems / Computer Equipment / Switch

Cisco Systems WS-C6513-E-RF Requirements, Ad-Hoc Conferencing and Transcoding Port Adapter, Color

Models: 6513-E 6500-E WS-C6513-E-RF

1 34

Download 34 pages 43.44 Kb

Page 6

Ad-Hoc Conferencing and Transcoding Port Adapter

Requirements

Figure 3

24-Port FXS Port Adapter Front Panel Features

Receive port LEDs

WS-SVC-CMM-24FXS

FXS Interface Board Adapter

98289

RJ-21 connector

Table 4

24-Port FXS Port Adapter Receive Port LEDs

Color

Green

Off

Description

Port is off-hook or ringing.

Port is not active (connected device on-hook) or is disabled through the CLI.

Ad-Hoc Conferencing and Transcoding Port Adapter

The front panel features of the ad-hoc conferencing and transcoding port adapter are shown in Figure 4, and the STATUS LED is described in Table 5.

Figure 4			Ad-Hoc Conferencing and Transcoding Port Adapter Front Panel Features
		WS-SVC-CMM-ACT
		WS-SVC-CMM-ACT

Ad-hoc Conferencing and Transcoding Port Adapter

99302

Table 5

Ad-Hoc Conferencing and Transcoding Port Adapter STATUS LED

Color

Green

Red

Off

Description

Port adapter is up and operational.

Port adapter is shut down.

Port adapter is not located by the system.

Requirements

These sections describe the hardware and software requirements:

•Hardware Requirements, page 7

•Software Requirements, page 7

Cisco Communication Media Module for Catalyst 6500 Series Switch and Cisco 7600 Series Router Installation and Verification Note

6

Image 6

Cisco Systems WS-C6513-E-RF, 6500-E Requirements, Ad-Hoc Conferencing and Transcoding Port Adapter, Color, Description

Contents

Product Number WS-SVC-CMM Contents Front Panel DescriptionsCMM Module Color Description6-Port T1 and E1 Port Adapters ColorDescription Description 24-Port FXS Port AdapterColor 6-Port T1 and E1 Port Adapters Receive Port LEDsColor RequirementsAd-Hoc Conferencing and Transcoding Port Adapter DescriptionHardware Requirements Safety OverviewWarning IMPORTANT SAFETY INSTRUCTIONS Software RequirementsWarning Ultimate disposal of this product should be handled according to all national laws and regulations. Statement Warning Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network interface. Statement Installing and Removing the Module Installing the ModuleRequired Tools Horizontal slots Installing and Removing the ModuleFigure 5 Positioning the Module in a Horizontal Slot Chassis Installing and Removing the ModuleSWITCH FABRIC MDL Insert module1 mm Gap between the module EMI gasket and the module above it Clearing the EMI Gasket in a Horizontal Slot ChassisVertical slots extended Positioning the Module in a Vertical Slot ChassisEjector lever fully EMI gasket EMI gasketGap between the module EMI gasket and the module above it 1 mm Press left Press leftRemoving the Module Ejector Lever Closure in a Vertical Slot ChassisTo remove a module from the chassis, perform these steps Horizontal slotsVertical slots Removing and Replacing Port Adapters Removing a Port Adapter from Module Slots 1 throughPhillips screws installed from bottom Module Bottom ViewStandoffs Figure 12 Module Top View with Port Adapters InstalledFigure 13 Module Top View with Port Adapters Removed Slot 4 PhillipsInstalling a Port Adapter in Module Slots 1 through Removing an Ad-Hoc Conferencing and Transcoding Port Adapter in Slot Page Verifying the Installation RJ-45 Port Connector and Cabling SpecificationsVerifying the Installation RJ-45 Port Connector and Cabling Specifications Pin1Figure 14 RJ-45 Port Connector DescriptionRJ-21 Port Connector and Cabling Specifications Figure 15 RJ-21 Telco Interface 90-Degree Cable ConnectorFigure 16 RJ-21 Telco Interface 180-Degree Cable Connector Signal Accessing the Port Adapter PortsConnector Pin PortConfiguring the Port Adapter Ports Configuring the Port Adapter Clock Sourceclock source line primary secondary 1..17 internal Supervisor Engine Model Disaster Recovery for Module Software UpgradesBoot/Power Management Option File Name AliasDisaster Recovery for Supervisor Engines Running Cisco IOS Software Password Recovery Password RecoveryCatalyst 6500 Series Switch Cisco IOS Software Configuration Guide Catalyst 6500 Series Switch Module Installation GuideCisco 7600 Series Router Module Installation Guide Cisco 7600 Series Router Cisco IOS Software Configuration GuideObtaining Documentation, Obtaining Support, and Security Guidelines