Cisco Systems WS-C6513-E-RF, 6500-E manual Color, Description

Front Panel Descriptions

Note For information on the supervisor engine LEDs, see the Catalyst 6500 Series Switch Supervisor Engine Guide at this URL: http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/hardware/Module_Installation/Sup_Eng_ Guide/supe_gd.html

Figure 1		CMM Front Panel Features
						Interface Module slots
WS-SVC-CMM						WS-SVC-CMM-6E1
WS-SVC-CMM-6E1
0	1	2	3	4	5	0	1	2	3	4	5
STATUS
Communication Media Module 6-Port E1 Interface Port Adapter.						6-Port E1 Interface Port Adapter.

	MDL
STATUS
REAR

68447

STATUS LED	REAR MODULE STATUS LED
Table 1	Module STATUS LED

Color

Off

Red

Orange

Green

Description

•The module is waiting for the supervisor engine to provide power.

•The module is not online.

•The module is not receiving power, which could be caused by the following:

–Power is not available to the module.

–Module temperature is over the limit1.

•The module is released from reset by the supervisor engine and is booting.

•If the boot code fails to execute, the LED stays red after power up.

•The module is initializing hardware or communicating with the supervisor engine.

•A fault occurred during the initialization sequence.

•If the module fails to download its Field Programmable Gate Arrays (FPGAs) on startup, it continues initializing and is granted module online status from the supervisor engine, but the LED stays orange.

•If the module is not granted module online status from the supervisor engine, the LED stays orange. This problem could be caused by the supervisor engine detecting a failure in an external loopback test that it issued to the module.

•The module is operational; the supervisor engine has granted module online status.

1.Enter the show environment temperature mod command to display the temperature of each of the four sensors on the module.

Cisco Communication Media Module for Catalyst 6500 Series Switch and Cisco 7600 Series Router Installation and Verification Note

3