Cisco Systems C3850NM41G manual Remove the 10-Gigabit Ethernet module slot EMC plug, and save it

Chapter 3 Installing a Network Module

Installing a Network Module in the Switch

Step 3

Caution

Caution

Caution

Remove the 10-Gigabit Ethernet module slot EMC plug, and save it.

Verify the correct orientation of your module before installing it. Incorrect installation can damage the module.

Do not install the network module with connected cables or installed SFP modules. Always remove any cables and modules before you install the network module.

Amodule interface might become error-disabled when a network module with connected fiber-optic cables is installed or removed. If an interface is error-disabled, you can reenable the interface by using the shutdown and no shutdown interface configuration commands.

Step 4 Position the module face up to install it in the module slot. Slide the module into the slot until the back of the module faceplate is flush with the switch faceplate. Fasten the captive screws to secure the network module in place.

Figure 3-5 Installing the Network Module in the Switch

Catalyst 3850 48 PoE+

344199

C3850-NM-4-1G

Catalyst 3850 Switch Hardware Installation Guide

3-6 OL-26779-02