Operation Common to Each Mode
Setting the clock
1.Press and hold the [T] button for 1 second or longer to switch to the adjustment selection display.
2.Press the [
] button or the [
] button to select “CLOCK_ _E”.
3.Press the [
] button.
4.Press the [
] button or the [
] button to select the hour or the minute.
5.Turn the [VOLUME] knob either clockwise or counterclockwise to set the correct time.
∗ The clock is displayed in
6.Press the [
] button to store the time into memory.
7.Press the [T] button to return to the previous mode.
Note:
•You cannot set the clock when it is displayed with only the ignition on. If you drain or remove the car’s battery or take out this unit, the clock is reset. While setting the clock, if another button or operation is selected, the clock set mode is canceled.
Switching the spectrum analyzer display patterns
You can select one out of 8 patterns or set it to off.
∗The factory default setting is “PATTERN 1”. Each time you press the [SPE/ANA] button, the spectrum analyzer display pattern changes in the following order:
PATTERN 1 ➜ PATTERN 2 ➜ PATTERN 3 ➜ PATTERN 4 ➜ PATTERN 5 ➜ PATTERN 6 ➜ PATTERN 7 ➜ SCAN ➜ OFF ➜ PATTERN 1...
Note:
The spectrum analyzer display is unavailable during these operations below;
•Seek tuning and auto store in radio mode.
•Mute or pause.
•When “NO DISC” or an error message appears in the display.
Setting the sensitivity of the spectrum analyzer
∗The factory default setting is “MID”.
1.Press and hold the [T] button for 1 second or longer to switch to the adjustment selection display.
2.Press the [
] button or the [
] button to select “ANA SENS”.
3.Turn the [VOLUME] knob either clockwise or counterclockwise to set the sensitivity of the spectrum analyzer.
You can choose one of “LOW”, “MID” or “HIGH” for the sensitivity of the spectrum ana- lyzer.
4.Press the [T] button to return to the previous mode.
Setting the speed of the spectrum analyzer display
∗The factory default setting is “HIGH”.
1.Press and hold the [T] button for 1 second or longer to switch to the adjustment selection display.
2.Press the [ 
] button or the [ 
] button to select “ANA SPD”.
3.Turn the [VOLUME] knob either clockwise or counterclockwise to set the speed of the spec- trum analyzer display.
You can choose one of “LOW”, “MID” or “HIGH” for the speed of the spectrum ana- lyzer display.
4.Press the [T] button to return to the previous mode.
Entering titles
Titles up to 10 characters long can be stored in memory and displayed for radio or TV stations and CDs. The numbers of titles that can be en- tered for each mode are as follows.
Mode | Number of titles |
Radio mode | 30 titles |
CD mode | 100 titles |
TV mode | 15 titles |
CD changer mode | Number of titles |
CDC655z connected | 60 titles |
CDC655Tz connected | 100 titles |
CDC1255z connected | 50 titles |
1.Press the [FNC] button to select the mode you want to enter a title. (radio, CD, CD changer or TV)
∗ Titles cannot be entered for MDs with this unit.
2.Select and play a CD or a CD in the CD changer, or tune to an appropriate TV or radio station.
3.Press the [DISP] button and display the title.
4.Press the [T] button. “TITL” appears in the dis- play and the cursor position flashes.
20 ADZ625
