Handsfree Operations

English

Storing a preset telephone numbers

This function allows you to make direct call from the unit. There are 6 preset telephone numbers can be stored in the unit.

!CAUTION

Please avoid performing this operation while you are driving as you may lose your concentration on the road. Always be sure to park your vehicle and apply the parking brake in order to perform this operation.

Telephone numbers edit mode

1.Press the [ ] button to enter Telephone mode.

2.Press the [ , ] button to select “MEMORY 1” to “MEMORY 6”.

3.Push the [] knob to edit the num- bers. A blinking cursor on current digit will be displayed.

4.Turn the [ ] knob to select a num- ber.

5.Push the [ ] knob to go to next number input.

6.Push the [ ] knob at a blank or the last 16th digit (“ ” indicator will be dis- played) will store the numbers into memory.

Notes:

“+” can be allowed in the first digit only.

Maximum digit range: 16 digits.

Push and hold the [ ] knob for 1.5 seconds or longer at a non-blank digit will store the numbers into memory as well.

Press the [] button at anytime will cancel current operation and exit the Edit mode without saving the numbers. If no operation is performed for more than 10 seconds, the Edit mode is cancelled and returns to the previous display.

Clearing all digits

1.During Telephone Numbers Edit mode, turn the

[] knob to select a blank digit.

2.Push and hold the [] knob for 1.5 seconds or longer to clear all digits on the right side.

Note:

Digits on the left side will remain as it is. In order to clear all the digits, always select the first character and perform the above operation.

Deleting a digit

1.During Telephone Numbers Edit mode, turn the

[ ] knob to select a blank digit.

2. Push the [

 

 

 

] knob to delete cur-

 

 

 

 

rent digit.

Note:

Digits on the right side (if there is any) will be shifted to the left.

Incoming call

Whenever your car stereo is operating, the car stereo is in standby mode awaiting the next call, when an incoming call arrives the car stereo will mute automatically and the ring tone is reproduced through your carʼs speaker.

The car stereo will temporarily switch to Telephone Interrupt mode and caller ID will be displayed in the car stereo.

Notes:

Car stereo will be automatically set as default speaker output everytime when there is an incoming call.

Some phones choose to present the audio despite being told to route it to the car stereo. This duplication of audio is a device problem/feature but does not impair functionality.

During incoming call, caller ID and “Calling...” will be displayed. Caller ID and CLIP (Calling Line Identification Presentation) is dependent on mobile phone and service provider. However, incoming call with private telephone numbers (CLIR- Calling Line Identification Restriction) will not be displayed.

22 FB275BT / FB275BTB