Fixed Mount (TOYOTA, NISSAN and other ISO/DIN equipped vehicles)

WIRE AND INSTALLATION English MANUAL CONNECTION

This unit is designed for fixed installation in the dashboard.

If the vehicle is equipped with a factory-installed radio, install the main unit with the parts and screws marked (*). (Figure 8)

If the vehicle is not equipped with a factory- installed radio, obtain an installation kit to install the main unit in the following procedure.

1.Remove the screws from both side of the main unit. Then, at either side, lift the leaf spring until the engaging claws are released from the holes, and slide the spring to the direction of arrow to remove it. Repeat the same for the other side to remove the springs from the both sides. (Figure 7)

2.Secure the mounting brackets to the chassis as shown in Figure 8. Holes are pre-tapped for TOYOTA and NISSAN vehicles; modification, such as drilling new holes, of the mounting brackets may be required for other models.

3.Wire as shown in Section 8.

4.Secure the unit in the dashboard, and then reassemble the dashboard and the center panel.

2-Screw

Engaging claw

Main Unit

2-Spring

 

Screwdriver

 

Figure 7

 

Mounting bracket

4-Hexagonal screw ∗ (M5 ⋅ 8)

(1 pair for the left and right sides)

Center Panel (Note 1)

∗: The screws with this mark are enclosed in this set.

★: The parts and screws with this mark are used to install radio or included in the installation kit.

Main Unit

Pocket

Note 2

Note 1: In some cases, the center panel may require some modification (trimming, filling, etc.).

Figure 8

Note 2: If the hook on the installation bracket interferes with the unit, bend and flatten it with a nipper or a similar tool.

70 VRX766VD