6. REMOVING THE MAIN UNIT

1.When the rear of the main unit has been secured with the method shown in Figure 6 unfasten the special screw.

2.Remove the outer escutcheon.

3.Insert the hook plate between the spring and the universal mounting bracket, fit tab B of the spring into hole A of the hook plate, then pull the main unit out by the hook plate. (Insert both the right and left edges of the hook plate.) (Figure 9)

Universal mounting bracket

2-Hook plate

Note:

•Keep the hook plate. You cannot remove the main unit without disengaging the hook plate.

Instrument panel

Main

Unit

WIRE AND INSTALLATION English MANUAL CONNECTION

Spring

Outer escutcheon

A B

Figure 9

7. CAUTIONS ON WIRING

1.Be sure to turn the power off before wiring.

2.Be particularly careful where you route the wires.

Keep them well away from the engine, and exhaust pipe, etc. Heat may damage the wires.

3.If the fuse should blow, check to see if the wiring is correct.

If a fuse is blown, replace it with a new one of the same amperage rating as the original (15A FUSE).

4.To replace the fuse, remove the old fuse of the power supply lead and insert the new one. (Figure10)

Note:

•There are various types of fuse holder. Do not let the battery side touch other metal parts.

CAUTION

After the connection, fix the lead by a clamp or insulation tape for protection.

Fuse (15A FUSE)

Fuse holder

Figure 10

VRX766VD 71