English
7. OPERATIONS
Basic Operations | Note: Be sure to read this chapter referring to the front diagrams |
of chapter “2. CONTROLS” on page 5 (unfold). |
CAUTION
Be sure to lower the volume before switching off the unit power or the ignition key. The unit remembers its last volume setting. If you switch the power off with the volume up, when you switch the power back on, the sudden loud volume may hurt your hearing and damage the unit.
System check and speaker setting
During the initial power up of this unit, it will go through a system check procedure.
This procedure verifies any devices connected through CeNET. Any additional CeNET devices plugged into the unit after the initial power up will initiate the system check procedure.
Selecting a mode
1.Press the [SRC] button to change the operation source mode.
2.Each time you press the [SRC] button, the operation mode changes in the following order:
Radio mode ➜ DAB mode ➜ DVD mode ➜ CD changer mode ➜ TV mode ➜ AUX mode ➜ Radio mode...
∗External equipment not connected with CeNET is not displayed.
Adjusting the volume
Turn the [ROTARY] knob to adjust the volume.
∗The volume level is from 0 (minimum) to 33 (maximum).
When the power is turned on, “SYSTEM CHK” appears in the display if the wire connections were modified.
The system check starts automatically within the unit.
When the system check is complete, “SP- SETTING” appears in the display. Perform the speaker setting.
1.Turn the [ROTARY] knob to select the speaker system.
∗The factory default setting is “2ch”. (Adjustment 2ch/5.1ch)
2. Press the [ |
| ] button. |
∗The setting is complete and the display switches to the radio mode.
Turning on/off the power
Note:
•Be careful about using this unit for a long time without running the engine. If you drain the car’s battery too far, you may not be able to start the engine and this can reduce the service life of the battery.
Switching the display
●When the power is turned on
Each time you press the [DISP] button, the display switches in the following order:
Main display ➜ Clock display ➜
Main display ...
∗Once selected, the preferred display becomes the display default. When a function adjustment such as volume is made, the screen will momentarily switch to that function’s display, then revert back to the preferred display several seconds after the adjustment.
CT (Clock Time) function
The CT function receives CT data sent from an RDS station and displays the time. Press the [DISP] button to switch to the CT display.
∗If a CT data is not being received,
Note:
•CT data is not transmitted in some countries and by some broadcast stations. Also, in some areas, the CT may not display accurately.
1.Press the [SRC] button.
2.The illumination and display on the unit light up. The unit automatically remembers its last operation mode and will automatically switch to display that mode.
3.Press and hold the [SRC] button for 1 second or longer to turn off the power for the unit.
Setting the Z-Enhancer Plus
This unit is provided with 4 types of sound tone effects stored in memory. Select the one you prefer.
∗This function cannot be adjusted when as follows: “Pro Logic” is set to “ON”, the speaker system is set to “5.1ch”,
14 VXZ758R