Classe Audio SSP-60 owner manual Display Setup, Display setup TV system

5.3.4Balanced source: This sub menu permits you to assign the analog balanced input to any of the sources, (AV1- AV6 and AUD1- AUD4). Use the > or the < keys to scroll through the choices. In the “Off” setting, the balanced input is disabled.

5.3.5Balanced routing: This sub menu gives you the choice to route the balanced input through the DSP or to use it in “BYPASS” mode.

PLEASE NOTE THAT WHEN THE BALANCED SIGNAL ROUTING IS SET TO BYPASS, THE BALANCED INPUTS WILL BE ROUTED TO THE LEFT AND RIGHT BALANCED OUTPUTS ONLY (via the volume control).

WHEN THE BALANCED ROUTING IS SET TO DSP, THE STEREO, STEREO96, PRO-LOGIC, PLII MOVIE, PLII MUSIC, NEO6 CINEMA, NEO6 MUSIC, NATURAL, PARTY AND MONO MODES ARE AVAILABLE.

5.4DISPLAY SETUP:

These settings are mainly “set and forget”, with the possible exception of OSD output. We have shipped your SSP-60 with the “TV System” set to the correct format for your Country. If you are, however, having trouble with the picture it may be that the wrong format is set. This is easy to correct. Using the display on the front panel of the SSP-60, navigate to the Display setup screen and change the format to PAL or NTSC, whichever is correct for your TV and DVD player.

Display setup
> TV system	NTSC
Superimpose	On
Temporary disp.	Full
Video format	Auto
OSD output	Both
Distance units	Feet
OSD style	1
Exit

These displays show that you have accessed the Display setup sub-menu and highlighted TV System. You can scan through the available choices by pressing the \/ and /\ buttons on the remote. When the selection you wish to adjust is highlighted press the < or > key to scroll through the choices. To leave the menu and save the settings scroll down to Exit and press the ENTER key.

Display setup
TV system	NTSC

TV Display Panel Display

5.4.1TV System: Use < or > to switch between NTSC and PAL.

5.4.2Superimpose: Use < or > to change. “On” superimposes text over the TV picture, while “Off” allows the OSD to completely replace the TV picture.

5.4.3Temp. Display controls how long any On Screen Display remains present. Use < or > to change. It is possible to set the parameter to “Full” (on all the time), “Simple” (on for a few seconds), or “Off” (disables OSD entirely).

5.4.4Video Format can be set to S-Video output or Composite, or Auto. “Auto” automatically selects the best source present. Use < or > to change.

5.4.5OSD Output Use < or > to change. OSD can be applied to the Composite, or S-Video Monitor outputs, or both, or it may be switched Off. OSD is not available on the “NO OSD” outputs.

5.4.6Distance unit is setup in feet or meters for use in the Delay Setup sub menu.

5.4.7OSD style changes the screen and text color if “Superimpose” is switched Off.

5.4.8Exit returns to the Main Menu.

23