ClearOne comm 600/900 user manual Product Overview, RF Radio Frequency Controller, Mixer

4 Introduction — Product Overview

Product Overview

RF (Radio Frequency) Controller

The RF controller allows you to manage all calls, program user preferences and adjust settings for your RAV.

1	2	3
4	5	6
7	8	9
*	0	#

Key Functions

LCD Icon			Function
			Indicates commands are received and acknowledged by base unit
	ANTENNA		and represents the signal strength from the base unit to the controller.
	SIGNAL
			Indicates battery level
	BATTERY
		Key	Function
			Press to activate the phone and access the dial tone. Press
	ON/OFF		again to hang up the phone.
			Press to use call forwarding, access call waiting, or make a three-way
	FLASH		conference call (if supported by your telephone service).
			Press once to mute microphones during a call.
	MUTE		Press again to unmute.
			Press and hold for two seconds to display the status of the RAV.
	STATUS
			Press once to dial the last number called.
	REDIAL
			Press once to access the controller programming menu.
	MENU		Once you are in the Menu, this key serves as the Enter key.
	ENTER
			Press once to dial stored numbers.
PHONEBOOK			When you are in the Phonebook, use this key to delete characters or to
			go back to the previous screen.
	CLEAR
			Press down or up to navigate through the menu and phonebook.
DOWN UP
	VOLUME		Press while on a call to adjust call volume and ringer.

Introduction— Product Overview 5

Mixer

Front

A BC D

Figure 1.2. Mixer front

A.Telephone LED.This indicator lights red when the RAV is powered, but the telco is on hook (not in use).The indicator lights green when the telco is off hook (in use) and flashes green during an incoming call.

B.Microphone status LEDs. Nine indicators (RAV 900) or six indicators (RAV 600) indicate the activation status of the microphone elements. When a microphone element is activated, the corresponding LED lights green. When microphones are muted, all LEDs turn red.

C.Meter LEDs. These LEDs represents audio from all inputs.

D.USB port.This port enables USB connection to a PC.

Back

ANTENNA

Figure 1.3. Mixer back

A.Telephone Set, Line. RJ-11 connection to an analog telephone jack and an analog telephone set.

B.RF antenna connector. Connect the external RF antenna to this port.

C.RS-232. RS-232 control port for connection to a control system such as AMX or Crestron or to a computer.

D.Camera Control. VISCA camera control port.This connection enables microphone activa- tion to trigger camera presets (voice tracking).

E.LAN.This is a 10/100 BaseT auto-detecting Ethernet port for system control through a data network.

F.Mic Pod In. Use a Cat. 5 cable with RJ-45 connectors to connect the microphone pods.

G.Playback In/Record Out. RCA connection to record/playback devices such as a VCR.

H.Line In/Out. RCA connection to a codec, amplifier or sound card.

I.Speaker Output. Use speaker wire to connect these push terminals to the Bose loudspeakers.

J.Power 12 VDC. Power supply.

Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760 Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760