when not in use and off the base, the low battery icon will appear on the Caller ID display. Place on the base to recharge. If not, after 4 hours the phone will be dead and you will need to recharge for 24 hours before using.
Important Information…Please Read
Battery Life
Fully charged batteries provided an average talk time of about 4 hours, or standby time of about 8 days. Talk time & standby time may vary depending on operating conditions.
Belt Clip Installation
You may choose to use the optional belt clip provided with your handset
1To attach, slide the belt clip down onto the grooves. Press the tabs on the belt clip into the slots to attach.
2To remove, lift one side of the belt clip with your thumbnail and push back.
A55 Handset Registration
You will need to wait 24 hours after initial charging before setting up any features listed below.
Handset Registration
The Handset is already
1Make sure the base unit is connected into the AC outlet and phone jack.
2Remove the handset from the charging base and place it near the main base. If you have more than one handset, or are adding additional handsets, place the extra handsets near the main base.
3Press and hold the /PAGE button on the base unit. After 3 seconds, press the “CH” button on the handset, and the unit will give a confirmation beep, which means that the code has been set and the handset will show
4If you have more than one handset, press the “CH” button on the handset until you get a beep and the display reads
NOTE: The /PAGE button on the base unit should be kept pressed during the whole procedure. When registering multiple handsets, it is important that you do not lift your finger off the page button in
