PRODUCT VALVE

Daily

- clean product valve as follows:

1.
Open product valve.
2.
Disconnect air hoses.
3.
Remove air cylinder.
4.
Remove valve tee.
5.
Remove all O-rings.
6.
Clean air cylinder, do notsubmerge in water. Wipe
clean and sanitize.
7.
Clean and sanitize tee and O-rings.
8.
Grease and reinstall O-rings.
9.
Reinstall tee to kettle outlet.
10.
Reinstall air cylinder to bottom of tee.
11.
Reconnect air hoses.
12.
Close valve and check for alignment.
SCRAPER BLADES

To remove and clean scraper blades:

1. Remove scraper blades using the tool to release
the spring from the retaining pin and sliding the
blade off the shaft.
2. Place parts in a pan of warm water to soak.
3. Clean in a sink, using a warm water and mild
detergent solution.
4. Rinse with fresh water.
5. Allow to dry thoroughly on a flat, clean surface.
AIR HOSE
AIR
CYLINDER
AIR HOSE
OPEN
POSITION
CLOSED
POSTITION
0-RING
CLAMP
0-RING
VALVE
TEE
0-RING
CLAMP
KETTLE
OUTLET
KETTLE
Fig. 2 Fig. 3Fig. 1
Scraper
blade
Back stop
Pin A
Pin B
Tool
Spring
To Install Scraper Blade
1. Slide scraper blade and spring onto Pin A as shown in Fig. 1.
2. Hook spring arm and pull up.
3. Using tool, engage spring arm into groove on Pin B.
Scraper blade is now in place.
To Remove Scraper Blade
1. Insert tool that is provided as shown in Fig. 2.
2. Pull up on spring arm until arm clears groove in Pin B.
3. Spring is now disengaged, gently release spring to remove
scraper blade.