
Disassembly
2.Disassembly
NOTE: All disassembly procedures assume that the system is turned OFF, and disconnected from any power supply (the battery is removed too).
Maintenance Tools
The following tools are recommended when working on the notebook PC:
•M3
•M2.5
•M2
•Small
•Pair of
•
Connections
Connections within the computer are one of four types:
Locking collar sockets for ribbon connectors | To release these connectors, use a small |
| the locking collar away from its base. When replacing the connection, make |
| sure the connector is oriented in the same way. The pin1 side is usually not |
| indicated. |
Pressure sockets for | To release this connector type, grasp it at its head and gently rock it from side |
| to side as you pull it out. Do not pull on the wires themselves. When replacing |
| the connection, do not try to force it. The socket only fits one way. |
Pressure sockets for ribbon connectors | To release these connectors, use a small pair of |
| lift the connector away from its socket. When replacing the connection, make |
| sure the connector is oriented in the same way. The pin1 side is usually not |
| indicated. |
To separate the boards, gently rock them from side to side as you pull them | |
| apart. If the connection is very tight, use a small |
| just enough force to start. |
2 - 2 Overview