Clevo M760TU, M740TU manual Removing the Inverter Board, Inverter Board Removal

Removing the Inverter Board

1.Turn off the computer, and remove the battery (page 2 - 5).

2.Remove any rubber covers, screws 1 - 6 (Figure 9a), then run your finger around the middle of the frame to carefully unsnap the LCD front panel module 7 from the back.

3.Discharge the remaining system power (see “Inverter Power Warning” below).

4.Remove screw 8 (Figure 9b) from the inverter, and carefully lift the inverter board up slightly.

5.Disconnect cables 9 & 10 (Figure 9c) from the inverter, then remove the inverter 11 (Figure 9d) from the top case assembly.

Disassembly

Figure 9

Inverter Board

Removal

a. Remove the 6 screws and unsnap the LCD front panel module from the back.

b. Remove the screw and discharge the remaining power from the inverter

a. 2 3 4 5

1 6

7



Inverter Power Warning

In order to prevent a short circuit when re- moving the inverter it is necessary to dis- charge any remaining system power. To do so, press the computer’s power button for a few seconds before disconnecting the in- verter cable.

b.

8

c.

9 10

d.

11

board and lift the board up slightly.

c. Disconnect the cables from the inverter.

d. Remove the inverter.



7.LCD Front Panel

11.Inverter Board

• 6 Screws

2.Disassembly

Removing the Inverter Board 2 - 13