CMA Dishmachines CMA-180UC manual Screen 22 must be set to “1” Door

Brown (LIVE) wire

Multi-conductor cable

Rinse Signal wires

Detergent Signal wires (Blue terminals) (Red terminals)

Black (Main Power)

Gray/Violet

(Main Power Neutral)

(Same terminal as rinse neutral)

Note: Machine Neutral

(White wires)

Figure 2.2.3

Note: In Figure 2.2.3 the machine’s wire harness was left out of the back of the power block to more clearly show the dispenser wires.

2.Remove the plug from the mixing chamber located by the vacuum breaker on the back of machine; and install the rinse injection fitting (supplied with your dispenser). See Figure 2.2.4.

Figure 2.2.4.

3.A 7/8" detergent injection hole is provided in the back of the wash tank. Remove the S.S. plug and install the detergent fitting (supplied with your dispenser).

4.The final step of installing the CMA supplied Detergent and Rinse Dispenser is programming it to your specific application. The reference manual supplied with the dispenser shows you how to program it.

Keep in mind while reading the reference manual that the CMA-180UC operates in “probe-less” mode. (This mode is selected by setting a value of “2” in screen 21).

Screen 22 must be set to “1” (Door).

MODEL CMA-180UC INSTALLATION & OPERATION MANUAL Rev. 1.15 Page 7