Cobra Electronics MR HH425LI owner manual Initial Charge, To Remove Battery Pack from Radio

Models: MR HH425LI

1 42
Download 42 pages 34.46 Kb
Page 22
Image 22

Installation

Power Sources

Remove Charger Spacer

Initial Battery Charge

36 English

Batteries and Charger

Initial Charge

The Cobra-provided lithium-ion (LiON) battery pack may be charged at home, in a car or in a boat using the appropriate 12V or 120V power cord with the charger.

1.Insert one (1) of the power cords into the back of the drop-in charger.

2.Insert the other end of the power cord into the appropriate 12V or 120V power source.

3.Remove the spacer from the charger and insert the entire radio into the charger. The metal charge contacts on the radio will contact the mating prongs in the charger to transfer the charging current.

4.Observe that the red light on the front of the charger glows to indicate that the battery pack is properly seated and the charger is operating.

5.Allow the batteries to charge for three (3) to four (4) hours before use. The light will change back to green when the battery is fully charged.

WARNING

Only the rechargeable lithium-ion (LiON) battery pack can be recharged. You MUST use one of the charging devices provided with this radio. Do not substitute any other type of charging adapter or charger base for this radio. Battery damage, fire or explosion may result. It is equally important to prevent the lithium- ion (LiON) battery pack from freezing to obtain best performance from the battery pack.

NOTE

If the drop-in charger is used on a boat, Cobra recommends you attach it to a horizontal shelf or vertical bulkhead (using the screw holes provided) to prevent possible damage due to the boat rolling or pitching. The charging base has been designed to hold the battery pack in place during rough sea conditions.

Installation

Locking Tab

Battery Pack Charging Only

Alkaline Battery Tray

Batteries and Charger

To Remove Battery Pack from Radio

1.Pivot the locking tab off of the back of the battery pack to unlock.

2.Lift the bottom of the battery pack slightly to remove it from the radio housing.

3.Pull battery pack out of the radio housing.

NOTE

The lithium-ion (LiON) battery pack can also be charged in the battery charger without being installed in the radio. Insert the spacer into the battery charger to support the battery pack during this charging process. Follow the same procedures in “Initial Charge” to charge the battery pack.

NOTICE

Lithium-ion (LiON) batteries are toxic. Please dispose of properly. Some marine suppliers accept old battery packs for recycling and some municipal waste disposal agencies have special provisions for battery disposal.

Alkaline Batteries

There is an alkaline battery tray (P/N CM 110-011) provided with this radio. The alkaline battery tray is provided as a backup or “Emergency” power source should the battery pack run low on power and needs to be recharged. The radio will transmit at full power when using six (6) new AA Alkaline batteries.

WARNING

Never attempt to recharge alkaline batteries. They are not made to be recharged, and should be disposed of in a proper manner.

Nothing Comes Close to a Cobra® 37

Page 22
Image 22
Cobra Electronics MR HH425LI owner manual Initial Charge, To Remove Battery Pack from Radio, Alkaline Batteries