Compaq H9A11 manual Introduction, Description

1

Introduction

1.1 Description

The H9A11 Cabinet (Figure 1-1) is a low-cost, computer-equipment enclosure system that meets the Electronic Industries Association (EIA) standard 310C and the International Electrotechnical Commission (IEC) 297 standards and can accommodate fixed or slide- mounted chassis that fit into a standard 48.26-cm (19-in.) rack.

The cabinet has the following factory installed features:

∙Equipment mounting rails with the EIA universal rail-hole pattern

∙Front trim kit that provides a finished look to the front opening of the cabinet

∙Vented rear lift-off door

∙Nonvented top cover

∙Four nonlocking casters that facilitate the placement of the cabinet. The front two casters swivel. The rear two casters are fixed.

∙Adjustable leveling feet that are used to stabilize and secure the cabinet at the installation site.

∙Stabilizer bar that is used to provide cabinet stability when installing or sliding equipment out of the cabinet.

∙A single-phase H7600-AA (120 Vac), H7600-AB (240 Vac), or H7600-DB (240 Vac) power distribution units (PDU) --- Each H7600-AA/AB power distribution unit provides ten (10) ac power outlets and each H7600-DB power distribution unit provides twelve (12) ac power outlets.

H9A11 Cabinet Installation/Owner’s Guide 1–1